INSTRUCTIONS FOR KIT #2005765                SINGLE 3” KIT     # 50-5921

FITS 2000-2004 GM ½ TON 4WD TAHOE/YUKON/EXCALADE W/4.8L/5.3L V8 ONLY, WITH 2-3/4" SINGLE FLANGED EXHAUST AT CONVERTER.  DOES NOT FIT DUAL INLET MUFFLER WITH 5.7L, 8.1L, 6.0L. 

NOTE:  DO NOT TIGHTEN ANY CLAMPS OR BOLTS UNTIL THE LAST STEP!

1)  REMOVE THE EXHAUST SYSTEM AT THE FLANGE BEHIND THE CONVERTERS LEAVING ONLY THE ORIGINAL Y PIPE, RUBBER MOUNTS, AND CATALYTIC CONVERTERS ON THE TRUCK.  YOU WILL NEED TO REUSE THE ORIGINAL NUTS OFF OF THE O.E. FLANGE.  DISCONNECT THE FACTORY HANGERS FROM THE ORIGINAL SYSTEM, LEAVING THE RUBBER HANGER MOUNTS IN PLACE. 

2)  INSTALL THE FLANGED FRONT PIPE TO THE CONVERTER FLANGE.  YOU MAY NEED TO TAP THE FLANGE ONTO THE BALL JOINT WITH A HAMMER TO INSTALL.  ROTATE THE PIPE TO CLEAR THE CROSS MEMBER AND INSTALL THE ORIGINAL NUTS LOOSELY ON THE FLANGE.  INSTALL THE WIRE HANGER THAT IS ON THE FLANGED FRONT PIPE TO THE O.E. RUBBER HANGER MOUNT.

3)  INSTALL THE MUFFLER TO THE EXTENSION PIPE (CENTER IN, SIDE OUT) USING A 3 CLAMP.

4)  INSTALL THE TAIL PIPE TO THE MUFFLER USING A 3” CLAMP.  CONNECT THE WIRE HANGERS ON THE TAIL PIPE TO THE O.E. RUBBER HANGER MOUNTS ABOVE.

5)  TIGHTEN ALL CLAMPS AND BOLTS AND CHECK FOR CLEARANCE OF THE FRAME, BODY, AND BRAKE AND FUEL LINES.

HARDWARE KIT FOR KIT #2005765  # 50-5921:

1)  FLANGED FRONT PIPE #2005766              1)  TAIL PIPE #2005708                      1)  MUFFLER #914

2)  3” CLAMPS

DANGER WARNING:  SHOULD THE PURCHASER DECIDE TO INSTALL THIS, OR ANY OTHER EXHAUST PRODUCT AT HOME, BE WARNED THAT PLEASURE CAR OR LIGHT DUTY TRUCK/VAN "BUMPER JACKS" ARE INTENDED FOR EMERGENCY USE ONLY.  THE USE OF FRAME CONTACT JACK STANDS IN CONJUNCTION WITH A FLOOR JACK AS MAIN SUPPORT IS HIGHLY RECOMMENDED TO MINIMIZE ACCIDENTAL DROPPING OF A VEHICLE WHILE THE INSTALLATION PROCEEDS.

Limitation of liability--Disclaimers:  The regulation of emissions production, noise levels and safety standards is undertaken by the federal government, each of the fifty state legislatures, and by many local municipalities, towns and counties.

                The manufacturer makes no warranties of merchantability, of fitness for a particular purpose, or that its products are approved for general use, or that its products comply with laws, regulations or ordinances in the states where they may be sold to the ultimate purchaser, the consumer.

                The entire risk as to the conformity of this product in any such state and as to repair, should the product prove to be defective or non-conforming, is on the retail purchaser, the buyer, the ultimate consumer of such product and it is not upon the seller, distributor, or manufacturer. 

                In this connection, retail purchaser, the buyer, the ultimate consumer assumes the burden of the entire cost of any and all necessary service, alterations, and or repair.

                The foregoing statement limits the liability of the manufacturer.

Heartthrob Exhaust Accessories are manufactured by CREMCO--Litchfield, Mn